the connor-winfield corp . 2111 comprehensive drive. aurora, il 60505.fax (630) 851-5040. phone (630) 851-4722. product da t a sheet specifications subject to change without notice. data sheet #: rev: date: page of copyright 2001 connor-winfield all rights reserved. a cr yst al controlled oscilla tors the connor-winfield fsld52te is a surface mount 3.3v fixed frequency crystal controlled oscillator (xo) with an hcmos tri-s tate output. the fsld52te is designed for applications requiring low jitter and tight frequency stability. 1 2 fsld52te - 156.25 mhz clock series center frequency 3.3v operation overall frequency tolerance: 50ppm temperature range: 0c to 70clow jitter <1ps rms tri-sta te enable/disable function surface mount p ackage tape and reel packaging s u r f a c e m o u n t 3 . 3 v h c m o s c l o c k o s c i l l a t o r fsl d5 2t e hc198 00 8/13/03 www.conwin.com ordering information features description absolute maximum ratings table 1.0 parameter units minimum nominal maximum units note storage temperature - 40 - 85 c supply voltage (vcc) - 0.5 - 7.0 vdc input voltage (vc) - 0.5 - 7.0 vdc operating specifications table 2.0 parameter minimum nominal maximum units note center frequency (fo) 19.44 - 167 mhz total frequency tolerance - 50 50 ppm 1 operating temperature range 0 - 70 c supply voltage (vcc) 3.0 3.3 3.6 vdc supply current 2 to 31.999 mhz (icc) - - 50 ma jitter (bw=10hz to 20mhz) - - 5 ps rms jitter (bw=12khz to 20mhz) - - 1 ps rms ssb phase noise at 10hz offset - - 75 - dbc/hz ssb phase noise at 100hz offset - - 100 - dbc/hz ssb ph ase noise at 1khz offset - - 125 - dbc/hz ssb phase noise at 10khz offset - - 135 - dbc/hz ssb phase noise at 100khz offset - - 140 - dbc/hz input characteristics table 3.0 parameter minimum nominal maximum units note enable voltage (vih) 2.0 - - vdc 2 disable voltage (vil) - - 0.5 vdc 2 hcmos output characteristics table 4.0 parameter minimum nominal maximum units note load - - 50 pf voltage (high) (voh) vcc - 0.5v - - vdc (low) (vol) - - 0.4 vdc current (high) (ioh) - 24 - - ma (low) (ioh) - - 24 ma duty cycle at 50% of vcc 45 50 55 % rise / fall time 10% to 90% - - 1.5 ns start up time - - 10 ms package characteristics table 5.0 p ackage non - hermetic package consisting of an fr4 subs trate with grounded metal cover. process recommendations table 6.0 solder reflow the component solder used internal to this device has a melting point of 221 c. the peak temperature inside the device should be less than or equal to 220 c for a maximum of 10 seconds wash ultrasonic cleaning is not recommended. notes 1.0 inclusive of calibration frequency at 25 c , frequency vs. temperature stability, supply voltage c hange, load change, shock and vibra tion and aging for ten years. 2.0 oscillator output is enabled with no connection on pad 1 cw 0701 fsld52te156.25m
the connor-winfield corp . 2111 comprehensive drive. aurora, il 60505.fax (630) 851-5040. phone (630) 851-4722. product da t a sheet specifications subject to change without notice. data sheet #: rev: date: page of copyright 2001 connor-winfield all rights reserved. a cr yst al controlled oscilla tors 2 2 hc198 00 8/13/03 www.conwin.com enable/ disable dimensional tolerance: .005 (.127mm) pin connection 1 enable/disable 2 ground 3 output 4 vcc 50pf c w f s l d 5 2 t e 1 5 6 . 2 5 m d a t e c o d e
|